Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| public:spot_-_3d_printing:load_filament [2024-09-07 15:47] – Simon Dorthe | public:spot_-_3d_printing:load_filament [2025-09-04 13:27] (current) – Sebastien Martinerie | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| [[https:// | [[https:// | ||
| + | |||
| + | Ok, so the video shows the MK3 procedure. Don't panic, the MK4 interface is even easier to use. | ||
| + | In the main menu, just go to Filament. You can then unload the filament if necessary, or just Load filament if the printer is empty. | ||
| + | The next steps are basically the same. Just follow the printer' | ||
| + | |||
| + | Easy! | ||
| + | |||
| + | |||
| + | ---- | ||
| + | |||
| + | And remember, the filament will give better results if it's dry! | ||
| + | So please, put back your spool in the drying cabinet after printing, whle being careful not to create tangles when handling the filament. | ||