Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| public:spot_-_3d_printing:filament_recycling [2026-02-27 14:18] – Sebastien Martinerie | public:spot_-_3d_printing:filament_recycling [2026-02-27 14:29] (current) – Sebastien Martinerie | ||
|---|---|---|---|
| Line 48: | Line 48: | ||
| **Settings you need:** | **Settings you need:** | ||
| - | - Printer: MK4 Input Shaper with 0.4 mm nozzle | + | |
| - | - Filament: SPOT PETG – MK4IS | + | |
| + | - Filament: SPOT PETG – MK4IS | ||
| + | - | ||
| See the wiki page for PrusaSlicer configuration [[public: | See the wiki page for PrusaSlicer configuration [[public: | ||
| **Please read carefully: | **Please read carefully: | ||
| - | - This filament is in beta-test mode. **For short and non-decisive parts ONLY!** | + | * This filament is in beta-test mode. **For short and non-decisive parts ONLY!** |
| - | + | | |
| - | - The filament might get stuck in the printhead from time to time. | + | |
| When this happens, the printer will pause and unload the filament. Cut the defect*, reload the filament and resume your print. | When this happens, the printer will pause and unload the filament. Cut the defect*, reload the filament and resume your print. | ||
| - | - Print during the day and stay here to be able to do the correction. | + | * Print during the day and stay here to be able to do the correction. |
| - | + | | |
| - | - Please give us your feedback on the sheet next to the printer so we can monitor defects frequency. | + | |
| *** Defects types** | *** Defects types** | ||